Replacement Heat Exchanger Pass for Recuperative Thermal Oxidizer

Cire Technologies is pleased to announce the completion the replacement of a recuperative thermal oxidizer heat exchanger pass.

This replacement heat exchanger was the third (hot side) pass of a 12,000 scfm recuperative unit in Massachusetts.  The heat exchanger is a stainless steel tube design that included provision for the high temperature thermal expansion of the tubes and head plate seals to prevent cross contamination of the air streams.


Cire Technologies was responsible for the complete turnkey project including design, fabrication and installation of the tube and shell heat exchanger.  In addition Cire Technologies supplied and installed replacement insulation between this heat exchanger pass and the oxidizer burner.  The project was delivered on time and on budget.

Cire Latest Blogs

Eric Becht
02 May 2014
At Cire Technologies we are very cognizant of our customers’ cost of operating our equipment. One area we excel at is reusing waste heat from our equipment back into the process. A current project ill...
Eric Becht
14 April 2014
Dryer Design
A Sample Dryer Project In this our last post on impingement dryer design we illustrate a simple set of dryer design calculations. Given: Tweb entry=60°FTweb exit=135°FTAir=220°F, TWeb=120°F or the wet...
Eric Becht
31 March 2014
Dryer Design
The Primary Components of an Impingement Dryer – Part 2 In this post we continue and finish the discussion of the primary components of an impingement dryer. Impingement Nozzles and Supply Plenums The...
Contact Us

logo-contactPlease complete the form below to contact us. 
We will respond within 24 hours to all requests.

251 Boulevard • Mountain Lakes, NJ 07046-1209
800-388-8301 • 973-402-8301 • Fax: 973-402-8302
1000 characters left